PS 1600 M1 with MT2 M1

The installation of the Pneumatic Seeder on the MT2 M1 Implement Carrier ensures flexible operation, since it does not need to be mounted directly on the trailed soil tillage implement. This results in ideal weight distribution: instead of putting the weight on the implement frame, the weight is shifted to the tractor rear axle.

The Pneumatic Seeder PS 1600 M1 is especially great for farmers with large cultivation surfaces, due to the large hopper volumes of 45.4 bushels. All components are perfectly adapted for intensive use.

Operations

The seeds are fed from the seed tank through the electrically controlled seeding shaft into the air duct. Here, the seeds are conveyed by air support through plastic hoses to the dispersion plates, and then evenly distributed close to the soil. This enables precise seeding even by windy conditions!

• Exact lateral distribution throughout the working width
• Precise spreading of seed, irrespective of wind
• Speed-adjusted seed rate spreading & headland management with sensors with sensors (optional)

• Different seeding shafts (fine seeds & coarse seeds)
• PS on MT2 can be combined with a large number of trailed soil tillage implements
• Reversible hopper cover
• PS on MT2 can be rapidly disconnected from the soil tillage implements (quick coupling systems)

• Fill level sensor signals when the hopper is low on seed¹
• Our largest hopper openings allow for loading with Bulk Bags
• Hopper discharge port & discharge function
• Equipped with implement monitoring sensors (pressure monitor, fill level sensor)